Windy days make it tougher to fish from almost any boat (even sailboats) but it is often just something that must be dealt with. The usual solution is to use an anchor, which I have been doing. Truth be told though, I wish there was something quicker and less involved.
Despite watching many YouTube videos where they were used I never thought to try one. Maybe this was because they were usually shown in clips about fishing in saltwater flats or bayous. I am usually in shallow water (less than 6 feet) because I primarily fish for bass but I never made the connection….duh!
Trial by Water
I made a quick prototype so I could experience the pros and cons. Suffice it to say, I was impressed! Here is a picture of the pole holding my W500. This was the same day I caught those 3 huge fish in my previous post.
The wind wasn’t too strong and it worked very well, even though it was only jammed about 6 inches into the mud. The real test came when I went to remove it from the lake bottom; it wasn’t easy! It took some effort, pulling straight up, to remove it. This told me it should work well in almost any wind that I would choose to fish in.
The pole is made of only 3 pieces:
- A heavy-duty, fiberglass driveway marker, 1/2 inch diameter and 4 1/2 feet long.
- A 3 1/2 foot section of a wooden dowel, 1 inch in diameter
- A PVC pipe T-connector
Here is a picture of the fiberglass driveway marker-
- Remove the cap from the fiberglass pole
- Drill a 3 inch deep hole in one end of the dowel
- Insert the fiberglass pole into the hole with a generous amount of epoxy
- Attach the T-connector to the other end of the dowel
The finished project with a piece of pool noodle, a tether and a carabiner attached-
Why did I wait so long? 🙂
Easy to make, inexpensive and effective. Using it is much easier, quicker and quieter then any anchor, conditions permitting. I highly recommend you make or buy 🙁 one ASAP.